PWM Control 60V BLDC Motor Driver Board For Hall Sensor Motors

9-60V BLDC motor driver board for Hall sensor motors, with PWM control and brake

BXSD‐0960‐15A‐MG

BLDC motor driver module
(For 120°Hall sensor BLDC motor)
Item Min Rated Max Remark
Input voltage(VDC) 9 24 60
Suitable for
12V/24V/36V/48V/60V
motors
Working current(A) 0.1 …. 17
Hall sensor voltage 4.5 … 5.5
Hall sensor angle(°) … 120 …
Can’t use for 60° Hall
sensor angle motors
Operating Temp.(℃) ‐20 24 60
Speed control 0‐5V, 10K/20K potentiometer ,PWM (200‐2000HZ),0‐100% duty cycle
Protections Locked‐rotor protection, Overvoltage, and overcurrent protection,
Application guidelines

1. Confirm that the voltage and power parameters of the motor do not exceed the range as specified.
2. Applicable to hall brushless dc motor with Hall at 120°, not all manufacturers' Hall line sequence are same,
you can adjust the Hall wires sequence and motor three‐phase sequence according to the actual situation, to
achieve the best driving effect.
3. BXSD‐0960‐15A‐MG is a BLDC motor driver board with a heatsink and built‐in connectors, it can be used for
12V,24V,36V,48V,60V motors, Please keep good ventilation for cooling if the motor is more than 300W.
4. The 5V output port(below 100mA) on the driver board is forbidden to connect external power equipment, It
is only applicable to external potentiometer and BLDC motor’s Hall sensors

Wiring diagram

1. Control port
5V — Driver board internal output voltage(below 100mA), external potentiometer, or switch for speed
adjustment
VI —Speed control port. Analog voltage linear speed regulation 0.1v ‐5V, The input resistance is 10K/20K
Ohm , connect with GND when input PWM speed regulation, PWM frequency:200‐1000HZ; Duty cycle 0‐100%
GND—Used for Driver board internal control
FB —Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V
low level or connect to GND is reverse direction.
BK —Brake function, 0‐5V analog voltage corresponding to 0‐100% braking force
SP— Speed pulse signal output

2. Power port
A ‐‐‐‐motor phase U
B ‐‐‐‐ motor phase V
C‐‐‐‐ motor phase W
GND ‐‐‐‐DC

VCC‐‐‐‐DC+

3:Hall sensor port

Ha‐‐‐ Hall a
Hb‐‐‐Hall b
Hc‐‐‐Hall c
GND‐‐‐GND
5V‐‐‐5V

4:Control port
VI—0‐5V /PWM speed control
FB—Forward/Backward
BK—Brake function (0‐5V linear brake, 0‐100% brake power)
SP—Speed pulse output.

5. Use shielded wires if the driver board has more than 50 cm distance from the motor, otherwise, it may lead
to abnormal driving, affecting the normal use.

6. Control port distance: 2.54mm, Power port distance:7.62 mm

Dimensional drawing

Height:30mm